Known as S2AS on the lake, on the beach or on the mountain. Established in 2002 Surface 2 Air Sports has become known, as the rider owned rider run extreme sports leaders in the UK.FacebookInstagramTwitterYoutubeGoogplePlusPinterest
<h2><strong>Take a look at the new Dakine Micro Lock at S2AS!</strong></h2><p>Roof rack security or après ski piece-of-mind, the Micro Lock provides gear security in a pocket-size package. Built from the same bomber materials as the larger Cool Lock, the Micro features a 30-inch cable and three-digit combo lock. Just enough security to offer a piece-of-mind for your unattended skis or board.</p><h3><strong>Features:</strong></h3><p>- 2 Year Limited Warranty<br/>- Compact 3-digit combination lock<br/>- 30" [ 76 cm ] retractable cable<br/>- Set your own combination</p>
<h2><strong>Dakine Spike Stomp Pad Now Available At S2AS</strong></h2> <p>One of the longest running products in our lineup of stomp pads, the Spike Stomp is still the best functioning and one of our best sellers. Why? Because the spikes are taller than most, which makes them more effective even with snow buildup. Pilot creases molded into the stomp let you trim down the overall size, or cut into strips to customize your traction.</p> <ul> <li>2 Year Limited Warranty</li> <li>Molded spike pattern for maximum traction</li> <li>Sections can be cut apart and reconfigured</li> <li>Peel and stick adhesive</li> </ul> <ul> <li>4.7" x 4.7" [ 120mm x 120mm ]</li> <li>2.2 oz [ 62g ]</li> </ul>
<h2><strong>Dakine Modular Mat Stomp Pad</strong></h2> <p>A perfect stomp pad for getting on and off the lifts, when you're unstrapped and you're looking for some stability these stomp pads add that bit of grip when the snow normally covers your board.</p> <p><strong>INSTRUCTIONS</strong></p> <p>1. Board and stomp should be at room temperature, 70 F [ 21 C ]</p> <p>2. Clean surface with rubbing alcohol. The surface must remain clean, smooth and dry. Do not touch.</p> <p>3. Use a blow dryer on high to heat up the prepared board surface as well as the adhesive on the traction device. 4. Immediately after heating, place the stomp and press firmly. Stand on the stomp without twisting, the more weight the better.</p> <p>5. Allow the adhesive to cure at room temperature for 24 hours.</p>
<h2><strong>Take a look at the Dakine Afterburner Paste Wax at S2AS!</strong></h2><p>Afterburner Paste Wax is a fluorinated paste wax that allows you to improve the glide of your snowboard or skis by applying it directly to the sole: perfect for last minute touch-ups on the piste.</p><h3><strong>Features:</strong></h3><p>- EVA applicator included<br/>- Direct application on a waxed sole or a waxed sole missing wax in certain areas<br/>- Spread the wax over the entire sole and polish with the supplied application pad<br/>- Universal fluorinated wax for all snow conditions<br/>- The most efficient paste wax in the range</p>
<h2><strong>Take a look at the new Dakine BC Tool Snowboard/Ski Multi-tool at S2AS!</strong></h2><p>A true purpose-built backcountry multitool, the BC Tool is designed with the needs of the modern backcountry user in mind. <br/><br/>An 8 and 10mm wrench plus all the essential bits and sizes—Phillips, Hex, Pozidrive, Flat Head—keep you from getting stranded deep out of bounds, but what really sets this tool apart is the multipurpose plastic scraper. Now that's something anyone who's spent time on a touring setup can attest to. Oh, and it wouldn't be complete without a way to pop the top on a beverage, hence the bottle opener.</p><h3><strong>Features:</strong></h3><p>- 2 Year Limited Warranty<br/>- Splitboarding / Ski touring backcountry tool|#1, #2 and #3 Phillips bits|<br/>- 2mm, 3mm and 4mm Hex bits<br/>- #3 Pozidrive bit<br/>- 1/4" Flat head bit|Bottle opener<br/>- 8mm and 10mm wrench<br/>- Multi-purpose plastic scraper</p>
<h2><strong>Take a look at the new Brethren Apparel Thug Rug Snowboard/Ski Riding Hood at S2AS!</strong></h2><p>The original cut that offers the ultimate face protection from the winter elements. Made out of 30% cotton and 70% polyester for a comfortable, warm and non-restrictive fit. Built with plenty of stretch, the Thug Rug can be worn under or over most helmets too, so style options are endless.<br/><br/>Ask anyone, no ones ever been cold snowboarding in a Brethren Thug Rug!</p><h3><strong>Features:</strong></h3><p>- O.G. Thug Rugs will fit over or under your riding lid, depending on the size of your noggin'.<br/>- Wash at 30°C,<br/>- Dry Flat, Don't tumble dry it. <br/>- 30% cotton, 70% polyester.</p>
<h2><strong>Take a look at the new Dakine Adjustable Tuning Iron at S2AS!</strong></h2><p>Dakine's Adjustable Tuning Iron is a dedicated waxing iron for ski and board care. A thick metal baseplate and tuned thermostat make for easy temp adjustment and even heat for a smooth hot-wax finish. Works with all hot waxes.</p>
<h2><strong>Take a look at the new Dakine Torque Driver Snowboard Tool (Green) at S2AS!</strong></h2> <p>The Torque Driver is the perfect tool for popping in your bag on your next off-piste adventure. Featuring the whole set of tools, you'll find everything you need hidden away in the handle!</p> <h3><strong>Features:</strong></h3> <ul> <li><strong>6 piece ratchet driver.</strong></li> <li><strong>Material: </strong>Plastic, Metal</li> <li><strong>#2 and #3 Phillips</strong></li> <li><strong>#3 Pozidrive</strong></li> <li><strong>3/32" Hex</strong></li> <li><strong>1/4" Flat head</strong></li> <li><strong>8mm and 10mm wrench</strong></li> <li><strong>Colour: Green</strong></li> </ul>
<h2><strong>Take a look at the new Dakine Stance Driver Snowboard Tool (Green) at S2AS!</strong></h2> <p>The Stance Driver is Dakine's most tricked-out driver tool ever! </p> <p>It comes with all the standard bits you'll need for your skis, snowboard, or surfboard, and the bidirectional adjustable ratcheting head makes quick work of any project. The retractable tape measure a fantastic additional feature that is always ready spring to help you set the perfect width on your bindings.</p> <h3><strong>Features:</strong></h3> <ul> <li>2 Year Limited Warranty</li> <li>6 piece ratchet driver</li> <li>#2 and #3 phillips</li> <li>#2 and #3 pozidrive</li> <li>3/32" hex</li> <li>1/4" flat head</li> </ul>
<p><strong>If you want to get the most out of your base you will have to wax it regularly. </strong></p> <p>TBT wax has been designed especially for Triple Base snowboards. TBT’s lifted sidebases have different angles to the snow than the flat centre base. This causes different friction values. When you apply TBT wax you optimize each base section for the ultimate glide!</p> <p>Features:</p> <p>- Wax for the side bases & wax for the centre base</p> <p>- Cold temperature wax</p> <p>- 230g</p>
<h2><strong>Check out the new Dakine 10" Snowboard/Ski Scraper at S2AS</strong></h2> <p>A trusty scraping tool is a must-have for any skier or snowboarder worth their wax. The 10" Scraper works great on skis, but its true calling is the snowboard life. Twice as wide as most standard scrapers, this one fits comfortably in hand and helps you get the job done in as few passes as possible. It's time to work smarter, not harder.</p> <p>Made of strong Acrylic plastic, you can also resharpen the edge if it gets dull.</p>
<h2><strong>Dakine Fidget Tool</strong></h2> <p>Check out this handy little keyring from Dakine! It contains the following tools:</p> <ul> <li>#2 phillips</li> <li>#3 posidrive</li> <li>3/32" hex</li> <li>1/4" flat head</li> </ul>
<h2><strong>Check out the new Dakine Indy Hot Wax - All Temp at S2AS!</strong></h2> <p>This is Dakine's all temperature hot wax, this should be good in most conditions and will make your base feel smoother and faster. Wax also takes care of your base by providing a layer of protective wax causing friction which melts snow crystals under the board.</p> <p>This melting of crystals not only protects the board from scratching but provides a super thin layer of water under the board which is what causes your speed to increase, Ironically the friction makes you go faster!</p> <p>It's called Indy Hot Wax, because that's how it has been designed to use, but here's a secret, you can rub it on too.</p> <p> </p>
<h2>Dakine High Octane Rub-On Wax - All Temp</h2> <p>This is Dakine's all temperature rub-on wax, this should be good in most conditions and will make your base feel smoother and faster. Wax also takes care of your base by providing a layer of protective wax causing friction which melts snow crystals under the board.</p> <p>This melting of crystals not only protects the board from scratching but provides a super thin layer of water under the board which is what causes your speed to increase.</p> <p>Ironically the friction makes you go faster!</p> <p>This is not as effective as a hot wax but is great for refreshing your board's base during the sticky start to the day.</p>
<h2><strong>Check out the Dakine Pyramid Studs at S2AS!</strong></h2> <p>A perfect stomp pad for getting on and off the lifts, when you're unstrapped and you're looking for some stability these stomp pads add that bit of grip when the snow normally covers your board.</p> <p>They are perfect for giving you reliable footing with your free foot, without taking up a ton of space on your board.</p> <p><strong>Instructions: </strong></p> <p>1. Board and stomp should be at room temperature, 70 F [ 21 C ]</p> <p>2. Clean surface with rubbing alcohol. Surface must remain clean, smooth and dry. Do not touch.</p> <p>3. Use a blow dryer on high to heat up the prepared board surface as well as the adhesive on the traction device. 4. Immediately after heating, place the stomp and press firmly. Stand on the stomp without twisting, the more weight the better.</p> <p>5. Allow the adhesive to cure at room temperature for 24 hours.</p>
<h2><strong>Check out the new Dakine Edge Tuner Tool now at S2AS!</strong></h2> <p>This is the only edge tuning tool you'll ever need. The Dakine edge tuner is a basic edge sharpening tool in order to get the most out of your ski or snowboard's edge. It comes with two preset setttings, 90 degrees and 88 degrees, use 90 for standard riding and 88 for racing.</p> <p>The Edge Tuner Tool combines convenience with practicality, for easy tuning anywhere. The large surface area easily rests against your base, positioning the file at just the right angle for the perfect edge. Dakine have thrown in an extra file, too, to keep your edges mint even longer. Just make sure not to iron metal scrapings into the base!</p> <p>This edge tuning tool is compatible with magnetraction snowboards.</p>
<h2><strong>Check out the new Dakine Super Tune Base Cleaner at S2AS!</strong></h2> <p>Supertune Base Cleaner is a citrus based degreaser. After warm spring rides or some unfortunate encounters with dirt/rocks/mud in the occasional tree well, this cleaner is the best way to remove the dirt and grime that cake the bottom of your skis or snowboard. Use it with a rag to clean your base, then do a regular hot wax treatment. You must clean your base before doing a new hot wax or you'll leave the dead wax in the board which will slow you down, this isn't the result you're after!</p> <p>It's also great on that layer of dust that accumulated in your garage over the summer!</p>
<h2><strong>Check out the new Dakine Supertune Ski/Snowboard Tuning Kit now at S2AS!</strong></h2> <p>This servicing kit is more advanced than the Deluxe kit from Dakine, it includes more tools such as a tuning iron which will allow you to do a hot wax, saving you a ton of money in the mountains.</p> <p>This tuning kit from Dakine has absolutely everything you need so that you never have to worry about paying for a service on your skis or snowboard ever again! A Edge Tuner for sharpening and removing burrs, a Metal File to de-tune the tip and tail and a Gummy Stone for polishing the edges to a perfect finish. The All-Temp Wax can be applied with the temperature-controlled Waxing Iron, then removed with the Plastic Scraper and the base structured with the Brass Brush and Finishing Pad. Lastly, any base repair can be dealt with thanks to the Ptex candles and Metal Scraper!</p> <p>From tuning and filing edges, to scraping, repairing, waxing, and polishing bases, it's the perfect kit to keep your ride in peak shredding condition throughout the year. The only things you can't do are fix delaminations and cracked/popped edges.</p> <p>The only kit you'll ever need to take to the mountains!</p> <h3><strong>Contents:</strong></h3> <ul> <li>Waxing Iron</li> <li>Brass Brush</li> <li>Finishing Pad</li> <li>Plastic Scraper</li> <li>Metal Scraper</li> <li>Ptex Candles </li> <li>Gummy Stone</li> <li>Metal File</li> <li>All Temp Wax</li> </ul>
A date has not been selected for this lesson. If you would like to select a date, choose cancel and select from the calendar. Otherwise continue with the booking, and contact us on (01202) 738 448 at anytime in the future to select a date.
